[. . . ] [. . . ] Drill hole for upper door hinge (top of panel) (Figure 3A). MODEL 2175: 23-3/4" MODEL 2115 and CLR2160: 14-3/4" Figure 1 Rear View of Wood Panel for Right Hand Hinge Shown. Create a relief (Figure 2) for pivot plate by cutting notch in top corner. Refer to the following figures for exact specifications. 0. 177" diameter (#16 drill) x 11/16" deep 4. 5/16" diameter x 1/4" deep 3/8" 13/32" Ø 5/16" X 1/4" DEEP CHAMFER 1/32" X 45" Figure 3B Bottom View of Door NOTE: It is important to ensure that all drilled holes are drilled to the correct depth in order to avoid splits in the wood when hardware is installed. U-Line Corporation Printed in U. S. A. [. . . ] [. . . ]